Researchers from Iran’s Babol Noshirvani University of Technology have investigated the enhancement of PV panel electrical efficiency by simulating a concentrating PV (CPV) system that integrates parabolic reflectors, a paraffin-based nanomaterials cooling system aimed at reducing solar module temperature, and a thermoelectric generator (TEG) that turns the excess thermal energy into electrical energy.
“To simulate the heat flux introduced by the reflectors, SolTrace software was employed, while the unsteady, three-dimensional thermal behavior of the system was analyzed using Ansys Fluent,” the researchers explained. “The innovation of the current article lies in the combined use of SolTrace for precise reflector modeling, heat flux variation analysis across PV layers, and the layered structure’s response to dust accumulation.”
A few cases were tested in the simulation program; the first, for reference, included only the CPV panel. In the second case, a cooling system has been implemented under the panel using a container filled with paraffin (RT35HC) enhanced with single-walled carbon nanotube (SWCNT) nanoparticles. In the third case, the container also included an array of fins to promote conductive heat dissipation across the PV panel surface.
All of those three cases were then tested under clean conditions as well as under dust deposition. Later on, all versions of the system were also equipped with a TEG. TEGs can convert heat into electricity through the “Seebeck effect,” which occurs when a temperature difference between two semiconductors produces a voltage difference between two substances.
“Simulated results demonstrated that, with the cooling system in place, the PV efficiency improves by approximately 16.46% in clean conditions. However, dust accumulation on the panel significantly impacts performance, reducing efficiency by around 46.48% after 60 min,” the academics stressed.
“The inclusion of fin structures further optimizes the system, boosting overall efficiency by approximately 6.77% in clean conditions and 3.78% under dust-affected conditions,” they added. “Thermal efficiency for the clean state increased by about 8.47% due to the fins.”
Concluding its work, the team said that “the combined effects of parabolic reflectors, fin-enhanced cooling, and TEG integration yield an electrical output power approximately 2.94 times greater than that of a PV panel without any reflector or cooling modifications.”
Their findings were presented in “Development of a new solar system integrating photovoltaic and thermoelectric modules with paraffin-based nanomaterials,” published in Scientific Reports.
This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact: editors@pv-magazine.com.
By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.
Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.
You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.
Further information on data privacy can be found in our Data Protection Policy.