From pv magazine USA
Pegasus Solar has unveiled InstaFlash, a new roof mount for solar installations on composite shingles. The mount is pre-installed with a watertight sealant designed to address roof irregularities and seal any missed pilot holes, cracked shingles and shingle seams.
It said the mount is designed to make it easy-to-install in a variety of composite roof configurations and weather conditions. The sealant instantly deploys when the mount is fastened to the roof, instantly creating a watertight seal. It seals any potential water ingress points under the entire footprint of the base.
Kai Stephan, chief executive officer of Pegasus Solar said that InstaFlash is “new guy proof,” as it “virtually eliminates the potential for user-error.”
The non-hardening sealant is housed in a cage that contains where the sealant spreads when deployed, preventing any messes and directing the material to the point where it is needed. InstaFlash can be installed in freezing temperatures or extreme heat (0 F to 170 F) and can be installed in rain without leaks.
For sloped roofs it can be installed on composition shingle or rolled asphalt, and for flat roofs it can be mounted on modified bitumen or built-up roofs.
“When a fastener lands in the so-called ‘slot-canyon’ between shingles, water can pass under a rigid tape, mastic or rubber-type barrier,” said Kai Stephan, chief executive officer of Pegasus Solar. “We realized we needed a semi-liquid sealant to fully penetrate and seal this gap to eliminate any potential for leaks.”
The mount comes with a 25-year warranty, is IBC and CBC code compliant, and UL certified. Full specification sheet can be found here.
“We approached this design from a clean slate,” said Stephan. “The guiding principle was, ‘What are the toughest challenges for a comp roof mount, and how can we solve those challenges with a product that’s easy enough for the newest installer to master?’”
Pegasus Solar also provides rail systems, tile scissor mounts, tilt leg kits, tile replacements, conduit and accessory mounts, MLPE brackets, and wire management systems.
This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact: editors@pv-magazine.com.
By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.
Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.
You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.
Further information on data privacy can be found in our Data Protection Policy.