Tesla gigafactory to combine Silevo, Panasonic HIT solar technologies

Share

More details have emerged regarding the plans for collaboration between Tesla and Panasonic at the SolarCity “gigafactory” under construction in Upstate New York. Citing SolarCity, Recharge reports that SolarCity has stated that it will be a combination of Silevo’s Triex and Panasonic’s Heterojunction Intrinsic Thin Film (HIT) technologies.

Tesla had earlier declined to clarify this matter for pv magazine, and there is no documentation of this on either Tesla’s or SolarCity’s website. However, this is par for the course for SolarCity and Tesla, and at the time of publication pv magazine was awaiting confirmation from SolarCity.

While both Panasonic and Silevo make silicon heterojunction solar PV, they are very different. Silevo was a start-up when it developed its Triex PV cell architecture only seven years ago, and while it began mass production in 2011, such production has remained at a relatively small scale. A year ago SolarCity/Silevo claimed that it had produced a 22.04% efficiency PV module, however the company has declined to provide information on the current efficiencies of mass-produced Silevo PV modules.

Panasonic, on the other hand, is a massive conglomerate that has decades of experience with silicon heterojunction devices, and has produced these modules at a much larger scale than any other manufacturer. The company is currently selling 330-watt, 1.7 square meter PV modules which offer 19.7% efficiency.

SolarCity’s Kady Cooper told Recharge that Panasonic will combine the best of the two technologies, however it is unclear how the Japanese PV maker will do that. While both designs incorporate a layer of crystalline silicon PV between two layers of amorphous silicon and while SolarCity notes that the tools used are similar, Silevo’s design is based on Metal Insulation Semiconductor PV technology, and in the past has emphasized the difference between the two.

Under the agreement, which is still a non-binding letter of intent, Panasonic will operate the factory and sell modules to SolarCity under long-term contracts. Of course, all of this is still dependent upon Tesla’s acquisition of SolarCity, which will go to a vote of shareholders on November 17.

This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact: editors@pv-magazine.com.

Popular content

Daikin launches air-to-water heat pumps for single-family homes

16 December 2024 Daikin has released a line of residential heat pumps, using propane (R290) as the refrigerant, with outdoor unit dimensions of 1,122 mm x 1,330 mm x 6...

Share

Leave a Reply

Please be mindful of our community standards.

Your email address will not be published. Required fields are marked *

By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.

Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.

You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.

Further information on data privacy can be found in our Data Protection Policy.